Insulated Sandwich Panels for Food, Pharmaceutical and Logistics Buildings

I go to many food factory and medicine cleanroom before. I know one thing very clear: normal wall will die very fast there! Everyday they use hot water to wash, strong chemical to clean, and health inspector check everywhere. You must use very strong material. That is why people now use sandwich panel with stainless steel surface. We call it cleanroom panel.

Let's talk about the surface first. Normal color steel will scratch and rust if you wash it with bleach everyday. But stainless steel will not. For normal food factory and C/D grade pharma cleanroom, 304 stainless steel is the best. Very smooth, no small hole, easy to clean.

But for A/B grade cleanroom, they use very strong chemical gas to clean. You must buy 316L stainless steel. It is much better than 304 for anti-chemical. If you use 304 there, it will break in few years. The thickness is usually 0.4mm to 0.6mm. Strong enough if forklift hit it, but worker still can carry it easy.

Inside the stainless steel, the core control the temperature. PIR foam is super good for insulation (only 0.018 to 0.020) and reach B1 fire rating. If you build big cold storage logistics warehouse and need -20 degree, PIR is your best friend. Your compressor machine will not run 24 hours.

If you worry about fire, Rockwool is Class A1 non-combustible. Inspector will be very happy! But thermal number is higher (0.033 to 0.045), so you must use thicker panel to keep cold.

Panel joint is also super important! Good panel use tongue-and-groove edge, worker put them very tight so no gap. In food and medicine factory, gap will hide bacteria and leak cold air. This is a disaster! So good worker always put flexible sealant glue in the joint. It stay soft in low temperature and will not wash away by hot water.